Pattern and other downloads

Everything you need to make the bag is here. The pattern is drawn 1:1. The inner line of each piece is the stitching line, and the outer line includes the 8 mm seam allowance.

Downloads

File What it is
Bag-2.0_Pattern_A4.pdf Main pattern for home printing: 10 A4 sheets to glue together
Bag-2.0_Pattern.pdf Main pattern on one A1 sheet (841 × 594 mm)
Bag-2.0_SidePocket_A4.pdf Side pocket, one A4 sheet
Bag-2.0_Pattern.svg Main pattern as SVG
Bag-2.0_SidePocket.svg Side pocket as SVG
Bag-2.0.FCStd FreeCAD 1.1 source file with the 3D model, flattened panels and pattern pages
LICENSE.txt License text

The pattern, the FreeCAD file, the photos and the texts are licensed under CC BY-NC-SA 4.0. You may share and adapt them if you give credit. You may not use them commercially. If you share an adaptation, it must use the same license.

Printing at the right scale

The PDFs are exact size. To print the tiled A4 version:

  1. Print with "Actual size" or 100 %. Turn off "Fit to page" and "Shrink oversized pages". Many print dialogs shrink the page a little even at 100 %.
  2. On sheet 1, measure the calibration marks before you cut anything. The square must be 20 mm, and the reference line 100 mm (99.5 to 100.5 mm is fine).
  3. If the square is too short (19.2 mm is the typical sign of shrinking), fix the printer settings and print again.

Glue the sheets together. Neighbouring sheets share a 3 cm strip of identical pattern, the paper overlaps by 4 cm. There are registration marks to be used with a light pad or a window.

The A4 sheets are made with svgtile, a small tool that tiles an SVG.

Pattern pieces

Each piece on the pattern is labelled with its name and how many to cut. Cut from the outer fabric unless the table says otherwise.

Name on the pattern Cut Fabric
Upper pocket 1 outer fabric
Lower pocket outer side 1 outer fabric
Lower pocket inner side 1 pocket fabric
Side panel 2 as printed, 1 mirrored outer fabric
Bottom (includes the narrow ends of the bag, where the pockets sit) 2 outer fabric
Top panel 2 outer fabric
Waterbottle holder 1 mesh
Zipper end 4 outer fabric
Side Pocket (separate sheet) 1 outer fabric or mesh
Elastics channel (separate sheet) 1 same as the side pocket

The Bottom and the Top panel are symmetric. Whether you need to mirror them for the second piece depends on your fabric. I did not mirror them.

All the paper pattern pieces cut out and laid on the cutting mat
The pattern pieces cut out of the glued paper.

The pattern

Drag to move, scroll or pinch to zoom. This is for looking only; print from the PDF.